This version of this provision extends to England and Wales and Scotland only; a separate version has been created for Northern Ireland only

This version of this provision extends to Northern Ireland only; a separate version has been created for England and Wales and Scotland only

Reg. 11(3) omitted (E.W.S.) (31.12.2020) by virtue of The Product Safety and Metrology etc. (Amendment etc.) (EU Exit) Regulations 2019 (S.I. 2019/696), reg. 1, Sch. 21 para. 8 (with Sch. 21 para. 37) (as amended by S.I. 2020/676, regs. 1(1), 2); 2020 c. 1, Sch. 5 para. 1(1)

Words in reg. 11(3) substituted (N.I.) (31.12.2020) by The Pressure Vessels (Amendment) (Northern Ireland) (EU Exit) Regulations 2020 (S.I. 2020/678), reg. 1(b), Sch. 1 para. 3(1)

http://www.legislation.gov.uk/uksi/2016/1092/regulation/11The Simple Pressure Vessels (Safety) Regulations 2016texttext/xmlenStatute Law DatabaseHEALTH AND SAFETYCONSUMER PROTECTION2025-03-17Expert Participation2024-10-01These Regulations transpose Directive 2014/29/EU of the European Parliament and of the Council of 26 February 2014 on the harmonisation of the laws of member States relating to the making available on the market of simple pressure vessels (recast) (OJ L 96, 29.3.2014, p.45) (“the Directive”).PART 2Obligations of economic operatorsManufacturersLabelling of vessels11.(1)

Before placing a vessel on the market, a manufacturer must ensure that the following appear on the vessel or its data plate—

(a)

a type and serial or batch identification allowing its identification; and

(b)

the following information—

(i)

the name, registered trade name or registered trade mark of the manufacturer; and

(ii)

a postal address at which the manufacturer can be contacted.

(2)

The information referred to in paragraph (1) must be clear, understandable and intelligible.

(3)

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Labelling of vessels11.(1)

Before placing a vessel on the market, a manufacturer must ensure that the following appear on the vessel or its data plate—

(a)

a type and serial or batch identification allowing its identification; and

(b)

the following information—

(i)

the name, registered trade name or registered trade mark of the manufacturer; and

(ii)

a postal address at which the manufacturer can be contacted.

(2)

The information referred to in paragraph (1) must be clear, understandable and intelligible.

(3)

The contact details referred to in paragraph (1)(b) must be in a language which can be easily understood by end-users and the competent national authority in the relevant state in which it is to be made available.